|
INITIAL SLOT MACHNE SETUP INSTRUCTIONS |
Before you can setup your machine, you have to get it out of it's shipping crate.
There are many staples holding the crate together. Remove the top using a hammer and a screwdriver or a prybar. Then remove one side panel the same way.
With a side panel and the top gone the machine will come out of the crate.
Now you can begin to set up the machine. If a stand is going to be used,
it must be capable of holding 250 lbs or more without colapsing.
Open the machine door by moving the sliding lock lever (Right side of machine)
all the way up. (Close the door by reversing this process.) (You may have
to slightly lift the door up or down in order to lock the lever all the
way in the down position) -You will find that the coin change/service lamp
that is normally attached to the top of the machine may have been removed
and placed inside the machines coin hopper for shipping purposes. It attaches
to the top of the machine with the 2 machine screws that are threaded into
the candle. - You will need to open the door on the machine and remove the
top glass in order to gain access to the under side where the candle mounts.
You will find a white colored quick connect plug in the area behind the
top glass that the lamp will plug into. Your jackpot reset key has been
placed into the reset switch lock located on the left side of the machine.
You will only use the reset key to reset the machines jackpot alarm when
someone gets lucky enough to get a jackpot or when changing games. (Otherwise
you will not need to turn this key) |
| You should notice that we left
a coin in the coin comparator which is located in the door of the machine.
This coin must remain in place or your machine will not accept coins and
you will get a tilt error code or the coin will jam. You will also find
the power cord inside the hopper. Route the power cord thru a small opening
in the back/bottom right side and plugs into a standard 110 volt outlet.
The power switch is just inside the door opening (Right side) - There’s
also a small white test switch located there. You don’t need to touch
that. Initially when the machine is powered on it will initialize a self
test and the reels will spin up. Anytime the door is opened and closed it
may or may not do the same reel spin test. |
| Try to keep the hopper full of
coins at all times. If you cash the machine out and run out of coins before
you run the credit counter down you will get a 3300 error on the display
which is cleared by adding quarters to the hopper and closing the door again
|
| The only maintenance you should
experience are normal wear things like replacing burned out light bulbs
and the occasional coin jam which is corrected by removing the jammed coin(s)
in the coin comparator. Another common problem is the Bill Vallidator cash
box is not inserted all the way or is mis-aligned which will cause your
Bill Vallidator NOT to function. Be sure it is inserted sqaurely and pushed
all the way in place. |
The tilt codes that you will run
into are reset and cleared by opening and closing the machine door. There
is an explanation of common error codes on the inside of the machine door
for you to refer to if you need to. Have fun with your slot machine and
if you should have any questions or concerns, please contact us so we can
help. Once again, we thank you for choosing us to make your purchase. -
Should you have any questions regarding the setup of your machine, please
give us a call at (623)869-9401 and we will do our best to help you out
over the telephone. 95% of all problems can be resolved over the phone.
The remaining problems could be caused by the machine being banged around
while in transit and might require a replacement part be sent to you. This
is very rare but it can and does happen. Don't panick! This is a casino
slot machine and is very reliable.
Thank you for your Business!
AZ SLOT LLC.
|
